Assigning Cos Components To Interfaces (J-Web Procedure) - Juniper EX Series User Manual

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Assigning CoS Components to Interfaces (J-Web Procedure)

64
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Class of
Service (CoS) on EX4600 switches.
After you have defined CoS components on an EX Series switch, you must assign them
to logical or physical interfaces. You can use the J-Web interface to assign scheduler
maps to physical or logical interfaces and to assign forwarding classes or classifiers to
logical interfaces.
To assign CoS components to interfaces:
Select >
1. Configure Class of Service
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select
See "Using the Commit Options to Commit Configuration Changes (J-Web
Procedure)" on page 31
To configure an interface association, select an interface from the list and click
2.
For an EX8200 Virtual Chassis configuration, select the member, the FPC, and the
interface from the list, and click
Select one of the following:
3.
Associate system default scheduler map
scheduler map.
Select the scheduler map
map. Select the scheduler map from the list.
NOTE: On the 40-port SFP+ line card for EX8200 switches, you cannot
commit your changes using the J-Web interface unless you assign the
same scheduler map or the default scheduler map to all interfaces in a
port group.
Click .
OK
4.
To manage a CoS assignment on a logical interface, Click one of the following options:
5.
>
Assign to Interface
for details about all commit options.
.
Edit
—Associates the interface with the default
—Associates the interface with a configured scheduler
Copyright © 2017, Juniper Networks, Inc.
.
>
Commit Options Commit
Edit
.
.