Defining Cos Scheduler Maps (J-Web Procedure); Note: This Topic Applies Only To The J-Web Application Package; Service (Cos) On Ex4600 Switches - Juniper EX Series User Manual

Table 37: Schedulers Configuration Page (continued)
Field
Transmit rate
Excess rate
NOTE: This option is
supported only on EX4300
switches.
Related
Documentation

Defining CoS Scheduler Maps (J-Web Procedure)

Copyright © 2017, Juniper Networks, Inc.
Function
Defines the transmission rate of a scheduler.
The transmit rate determines the traffic
bandwidth from each forwarding class you
configure.
By default, queues 0 through 11 are allotted the
following percentages of the transmission
capacity:
Queue 0—75 percent
Queue 1—0 percent
Queue 2—0 percent
Queue 3—5 percent
Queue 4—0 percent
Queue 5—0 percent
Queue 6—0 percent
Queue 7—0 percent
Queue 8—15 percent
Queue 9—0 percent
Queue 10—0 percent
Queue 11—5 percent
Defines the excess rate of a scheduler.
Defining CoS Schedulers and Scheduler Maps (CLI Procedure)
Example: Configuring CoS on EX Series Switches
Monitoring CoS Scheduler Maps on page 232
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Class of
Service (CoS) for EX4600 switches.
You can use the J-Web interface to configure CoS scheduler maps on an EX Series switch.
Chapter 5: Class of Service Configuration
Your Action
To define a transmit rate, select the appropriate
option:
To enforce the exact transmission rate, select
and enter a value.
Rate
To specify the remaining transmission
capacity, select
Remainder Available
To specify a percentage of transmission
capacity, select and type an integer
Percent
from 1 through 100.
To specify no transmit rate, select the blank
check box.
To define the excess rate, select the appropriate
option:
To specify a percentage of the excess rate,
select and type an integer from 1
Percent
through 100.
To specify no excess rate, select the blank
check box.
.
71