Juniper EX Series User Manual page 169

Table 74: Static Routing Configuration Summary (continued)
Field
Default Route
Static Routes
Nexthop
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Function
Specifies the default gateway for the
switch.
NOTE: IPv6 is not supported on
EX2200 and EX4500 switches.
Specifies the next-hop address or
addresses to be used when routing
traffic to the static route.
Configuring Static Routing (CLI Procedure)
Monitoring Routing Information on page 215
Layer 3 Protocols Supported on EX Series Switches
Chapter 11: Configuring Layer 3 Protocols
Your Action
To specify an IPv4 address:
1. Select .
IPv4
2. Type an IP address—for example,
.
10.10.10.10
3. Enter the subnet mask or address prefix.
For example, 24 bits represents
.
255.255.255.0
To specify an IPv6 address:
1. Select .
IPv6
2. Type an IP address—
for example,
2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address prefix.
To add an address:
1. Click .
Add
2. In the IP address dialog, enter the IP
address.
NOTE: If a route has multiple next-hop
addresses, traffic is routed across each
address in round-robin fashion.
3. Click .
OK
To delete a next-hop address, select it from
the list and click .
Delete
.
149