Table 54: Igmp Snooping Configuration Fields - Juniper EX Series User Manual

Table 54: IGMP Snooping Configuration Fields

Field
VLAN Name
Immediate Leave
Robust Count
Copyright © 2017, Juniper Networks, Inc.
To enable IGMP snooping and configure individual options by using the J-Web interface:
Select >
Configure Switching
1.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select
the Commit Options to Commit Configuration Changes for details about
all commit options.
Click one of the following options:
2.
—Creates an IGMP snooping configuration for the VLAN.
Add
—Modifies an IGMP snooping configuration for the VLAN.
Edit
—Deletes a selected VLAN from the IGMP snooping configuration.
Delete
When you are adding or editing an IGMP snooping configuration, enter information as
described in Table 54 on page
Click OK to apply changes to the configuration or click
3.
changes.
To disable IGMP snooping on a VLAN, select the VLAN from the list and click
NOTE: The Disable
Function
Specifies the VLAN on which to enable
IGMP snooping.
Immediately removes a multicast group
membership from an interface when it
receives a leave message from that
interface without waiting for any other
IGMP messages to be exchanged (IGMP
version 2 and IGMP version 3 only).
Specifies the number of timeout
intervals the switch waits before timing
out a multicast group.
Chapter 8: Ethernet Switching Configuration
> .
IGMP Snooping
Commit Options
105.
option is not available for EX4300 switches.
Your Action
Select a VLAN from the list to add it to
the snooping configuration.
To enable the option, select the check
box.
To disable the option, clear the check
box.
Type a value.
> . See Using
Commit
Cancel to cancel without saving
Disable .
105