Table 63: Edit Poe Settings; Table 64: Fpc Poe Settings - Juniper EX Series User Manual

Table 63: Edit PoE Settings

Field Description
Enable PoE Specifies that PoE is enabled on the interface.
Type Specifies whether the interface is PoE or PoE+.
Priority Lists the power priority (low or high) configured on
the interface enabled for PoE.
Maximum Power Specifies the maximum PoE wattage available to
provision active PoE ports on the switch.

Table 64: FPC PoE Settings

Field Description
FPC Specifies the FPC number.
Copyright © 2017, Juniper Networks, Inc.
Select >
1. Configure Power over Ethernet
The page displays a list of all PoE-capable interfaces for each FPC. Specific operational
details about an interface are displayed in the Details section of the page. The details
include the PoE operational status and port class.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select
the Commit Options to Commit Configuration Changes (J-Web
Procedure)" on page 31
Select one of the following options:
2.
—Changes PoE settings for the selected port as described in
Edit
FPC Settings —Changes PoE settings of PoE-capable FPCs.
To configure FPC settings, select one of the following options:
—Adds a PoE setting for an FPC as described in
Add
Edit —Modifies a PoE setting for an FPC as described in
—Deletes an existing PoE settings for an FPC.
Delete
.
Commit Options
for details about all commit options.
Table 64 on page
Table 64 on page
Your Action
Select this option to enable PoE or PoE+ on the
interface.
Select an option from the list.
Set the priority as
High
Select a value in watts. If no value is specified,
the default is 15.4 for PoE interfaces and 30.0 for
PoE+ interfaces.
Your Action
Select a value from the list.
Chapter 9: Interfaces
> . See "Using
Commit
Table 63 on page 121.
121.
121.
or .
Low
121