Table 65: Dhcp Service Configuration Pages Summary - Juniper EX Series User Manual

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Table 65: DHCP Service Configuration Pages Summary

Field
DHCP Pool Information
DHCP Subnet (required)
Address Range (Low)
(required)
Address Range (High)
(required)
Exclude Addresses
Lease Time
Maximum Lease Time
(Seconds)
Default Lease Time
(Seconds)
Server Information
Server Identifier
Domain Name
124
Enter information into the DHCP Service Configuration pages as described in
3.
Table 65 on page 124
To apply the configuration, click
4.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select
the Commit Options to Commit Configuration Changes for details about
all commit options.
Function
Specifies the subnet on which DHCP is
configured.
Specifies the lowest address in the IP address
pool range.
Specifies the highest address in the IP address
pool range.
Specifies addresses to exclude from the IP
address pool.
Specifies the maximum length of time a client
can hold a lease. (Dynamic BOOTP lease
lengths can exceed this maximum time.)
Specifies the length of time a client can hold a
lease for clients that do not request a specific
lease length.
Specifies the IP address of the DHCP server
reported to a client.
Specifies the domain name that clients must
use to resolve hostnames.
Apply .
Commit Options
Your Action
Type an IP address prefix.
Type an IP address that is part of the subnet
specified in DHCP Subnet field .
Type an IP address that is part of the subnet
specified in DHCP Subnet. This address must
be greater than the address specified in the
Address Range (Low) field.
To add an excluded address, type the
address next to the
To delete an excluded address, select the
address in the Exclude Addresses box, and
click .
Delete
Type a number from 60 through 4,294,967,295
(seconds). You can also type infinite to specify
a lease that never expires.
Type a number from 60 through 2,147,483,647
(seconds). You can also type infinite to specify
a lease that never expires.
Type the IP address of the server. If you do not
specify a server identifier, the primary address
of the interface on which the DHCP exchange
occurs is used.
Type the name of the domain.
Copyright © 2017, Juniper Networks, Inc.
> Commit . See Using
button, and click .
Add Add