Managing Licenses For The Ex Series Switch (J-Web Procedure); Table 82: Add An Authentication Server - Juniper EX Series User Manual

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Table 82: Add an Authentication Server

Field Function
IP Address Specifies the IP address of the server.
Password Specifies the password of the server.
Confirm Password Verifies that the password of the server is entered
correctly.
Server Port Specifies the port with which the server is
associated.
Source Address Specifies the source address of the server.
Retry Attempts Specifies the number of login retries allowed after
a login failure.
Time out Specifies the time interval to wait before the
connection to the server is closed.
Related
Documentation

Managing Licenses for the EX Series Switch (J-Web Procedure)

172
Configuring Management Access for the EX Series Switch (J-Web Procedure) on
page 52
NOTE: This topic applies only to the J-Web Application package.
To enable and use some Junos OS features on an EX Series switch, you must purchase,
install, and manage separate software licenses. Each switch requires one license. For a
Virtual Chassis deployment, two licenses are recommended for redundancy. After you
have configured the features, you see a warning message if the switch does not have a
license for the feature.
Before you begin managing licenses, be sure that you have:
Obtained the needed licenses. For information about how to purchase software licenses,
contact your Juniper Networks sales representative.
Your Action
Type the server's 32-bit IP address, in dotted
decimal notation.
Type the password of the server.
Retype the password of the server.
Type the port number.
Type the server's 32-bit IP address, in dotted
decimal notation.
Type the number.
NOTE: Only 1 retry is permitted for a TACACS
server.
Type the interval in seconds.
Copyright © 2017, Juniper Networks, Inc.