Monitoring Poe - Juniper EX Series User Manual

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
Meaning
Related
Documentation

Monitoring PoE

Purpose
Action
200
To view status and statistics for a specific interface, enter
.
xe-interface-name
To view status and traffic statistics for all interfaces, enter either
or
detail show interfaces xe- extensive
In the J-Web interface the charts displayed are:
Bar charts—Display the input and output error counters.
Pie charts—Display the number of broadcast, unicast, and multicast packet counters.
For details about output from the CLI commands, see
Ethernet) or show interfaces xe-
Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 109
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Power over
Ethernet (PoE) on EX4600 switches.
Use the monitoring functionality to view real-time data of the power consumed by each
PoE interface, and to enable and configure telemetry values. When telemetry is enabled,
the software measures the power consumed by each interface and stores the data for
future reference.
NOTE: If you are configuring a Virtual Chassis, the PoE monitoring option is
displayed if any member of the Virtual Chassis supports PoE, even if the
Virtual Chassis master does not support PoE.
To monitor PoE by using the J-Web interface, select
To monitor PoE power consumption with CLI commands in the CLI Terminal in the J-Web
interface:
Select >
1. Troubleshoot CLI Terminal
.
show interfaces ge-
(10-Gigabit Ethernet).
Monitor
.
Copyright © 2017, Juniper Networks, Inc.
show interfaces
show interfaces xe-
(Gigabit
> .
Power over Ethernet