Table 49: Create A New Filter - Juniper EX Series User Manual

Table 49: Create a New Filter

Field Function
Filter tab
Filter type Specifies the filter type: port or VLAN firewall filter
or router firewall filter.
Filter name Specifies the name for the filter.
Select terms to be Specifies the terms to be associated with the filter.
part of the filter Add new terms or edit existing terms.
Association tab
Port Associations Specifies the ports with which the filter is associated.
NOTE:
direction is supported for port association.
Copyright © 2017, Juniper Networks, Inc.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select
the Commit Options to Commit Configuration Changes for details about
all commit options.
Click one of the following options:
2.
—Select this option to create a new filter. Enter information as specified in
Add
Table 49 on page 91.
—Select this option to edit an existing filter. Enter information as specified in
Edit
Table 49 on page 91.
—Select this option to delete a filter.
Delete
—Select this option to move a term up in the filter term list.
Term Up
—Select this option to move a term down in the filter term list.
Term Down
For a port or VLAN filter type, only Ingress
Chapter 7: Routing Policies and Packet Filtering Configuration
Commit Options
Your Action
Select the filter type.
Enter a name.
Click to add new terms. Enter information
Add
as specified in Table 50 on page 92
Table 51 on page 93.
1. Click .
Add
2. Select the direction: Ingress or Egress.
3. Select the ports. For an EX8200 Virtual
Chassis configuration, select the member,
FPC, and the available ports from the list.
4. Click .
OK
> . See Using
Commit
and
91