Table 58: Aggregated Ethernet Interface Options - Juniper EX Series User Manual

Table 58: Aggregated Ethernet Interface Options

Field
Aggregated Interface
LACP Mode
Description
Interface
Enable Log
Copyright © 2017, Juniper Networks, Inc.
—Specifies IP options for the selected LAG. Enter information as specified
IP Option
in Table 60 on page 118.
—Deletes the selected LAG.
Delete
Disable Port or Enable Port
selected interface.
—Configures the number of aggregated logical devices available to
Device Count
the switch. Select the number and click
Function
Specifies the name of the aggregated
interface.
Specifies the mode in which Link
Aggregation Control Protocol (LACP)
packets are exchanged between the
interfaces. The modes are:
None —Indicates that no mode is
applicable.
Active —Indicates that the interface
initiates transmission of LACP packets
Passive —Indicates that the interface
responds only to LACP packets.
Specifies a description for the LAG.
Specifies the interfaces in the LAG.
Specifies whether to enable generation
of log entries for the LAG.
—Disables or enables the administrative status on the
OK .
Your Action
None. The name is supplied by the
software.
Select from the list.
Enter a description.
To add interfaces to the LAG, select the
interfaces and click
Virtual Chassis configuration, select the
member, FPC, and the interface from the
list. Click
To remove an interface from the LAG,
select the interface and click
NOTE:
configured with the same speed can be
selected together for a LAG.
Select the check box to enable log
generation, or clear the check box to
disable log generation.
Chapter 9: Interfaces
Add . For an EX8200
OK .
Remove
Only interfaces that are
.
117