Juniper EX Series User Manual page 142

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
Table 64: FPC PoE Settings (continued)
Field Description
PoE Management Specifies the power management mode. The options are
and
class
NOTE:
maximum power value is overridden by the maximum power value
for the interface that is connected to the switch on the PoE port.
When the power management mode is set to
the maximum power for each PoE interface.
Guard Band Specifies the amount of power reserved for power spikes from the
(watts) PoE power budget of the switch.
Maximum Power Specifies the maximum PoE wattage available to provision active
PoE ports on the FPC. For example, if you specify 1000 W, the PoE
controller is limited to a power budget of 1000 W to distribute to
the PoE ports.
Release History Table
Related
Documentation
122
.
When the power management mode is set to
Release
14.1X53-A2
Configuring PoE on EX Series Switches (CLI Procedure)
Example: Configuring PoE Interfaces on an EX Series Switch
Example: Configuring PoE Interfaces with Different Priorities on an EX Series Switch
Example: Configuring PoE on an EX6200 or EX8200 Switch
Monitoring PoE on page 200
Understanding PoE on EX Series Switches
static
class , the
, you can specify
static
Description
J-Web Application package Release 14.1X53-A2 does not support
Power over Ethernet (PoE) on EX4600 switches.
Your Action
By default, the power management
mode is . Select to change
class static
the power management mode.
Enter a value to set the guard band
value in watts. The default value is 0.
Select a value in watts.
Copyright © 2017, Juniper Networks, Inc.