Configuring Firewall Filters (J-Web Procedure) - Juniper EX Series User Manual

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
Table 48: Terms Configuration Parameters (continued)
Field Function
Route Specifies whether the route is external.
Preference Specifies the preference value.
Local Preference Specifies the BGP local preference attribute.
Class of Service Specifies and applies the class-of-service parameters to
routes installed into the routing table.
Source class
The value entered here maintains the packet counts for a
route passing through your network, based on the source
address.
Destination class
The value entered here maintains packet counts for a route
passing through your network, based on the destination
address in the packet.
Forwarding class
Related
Documentation

Configuring Firewall Filters (J-Web Procedure)

90
Configuring BGP Sessions (J-Web Procedure) on page 135
Configuring an OSPF Network (J-Web Procedure) on page 139
Configuring a RIP Network (J-Web Procedure) on page 144
Configuring Static Routing (J-Web Procedure) on page 148
Layer 3 Protocols Supported on EX Series Switches
NOTE: This topic applies only to the J-Web Application package.
You configure firewall filters on EX Series switches to control traffic that enters ports on
the switch or enters and exits VLANs on the network and Layer 3 (routed) interfaces. To
configure a firewall filter, you must configure the filter and then apply it to a port, VLAN,
or Layer 3 interface.
To configure firewall filter settings by using the J-Web interface:
Select >
Configure Security
1.
The Firewall Filter Configuration page displays a list of all configured ports or VLANs
or router filters and the ports or VLANs associated with a particular filter.
Your Action
Select the
option, and select the OSPF type.
Select the preference action and type a
value.
Select the action and type a value.
Type the source class.
Type the destination class.
Type the forwarding class.
> .
Filters
Copyright © 2017, Juniper Networks, Inc.
check box to enable the
External