Juniper EX Series User Manual page 133

Table 56: Port Edit Options (continued)
Field Function
Layer 2 Uplink Applies the Layer 2 uplink role.
The interface family is set to
mode is set to
point-to-point
for port security.
None Specifies that no port role is configured for the
selected interface.
NOTE: For an EX8200 switch, dynamic ARP inspection and DHCP snooping parameters are not configured.
VLAN Options
Port Mode Specifies the mode of operation for the interface:
trunk or access.
Link Options
MTU (bytes) Specifies the maximum transmission unit size (MTU)
for the interface.
Copyright © 2017, Juniper Networks, Inc.
ethernet-switching
, RSTP is enabled with the
trunk
option, and trusted DHCP is configured
Your Action
1. For this port role, you can select a VLAN member
and associate a native VLAN with the interface.
, port
2. Click Details to view CLI commands for this role.
3. Click .
OK
If you select Trunk , you can:
1. Click to add a VLAN member.
Add
2. Select the VLAN and click
3. (Optional) Associate a native VLAN with the
interface.
4. Click .
OK
If you select , you can:
Access
1. Select the VLAN member to be associated with the
interface.
2. (Optional) Associate a VoIP VLAN with the
interface. Only a VLAN with a VLAN ID can be
associated as a VoIP VLAN.
NOTE: VoIP is not supported on EX8200 switches.
3. Click .
OK
Type a value from
256
size for Gigabit Ethernet interfaces is
Chapter 9: Interfaces
.
OK
through . The default MTU
9216
.
1514
113