Juniper EX Series User Manual page 132

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
Table 56: Port Edit Options (continued)
Field Function
Desktop and Applies the desktop and phone role.
Phone
The interface family is set to
mode is set to
limit =1; dynamic ARP Inspection and DHCP snooping
enabled) are set, and recommended class-of-service
(CoS) parameters are specified for forwarding
classes, schedulers, and classifiers. See
Table 57 on page 115
To enable security configuration, select the
Security Configuration
forwarding-options dhcp-security groups
forwarding-options dhcp-security-arp-inspection
be configured.
Wireless Applies the wireless access point role.
Access Point
The interface family is set to
mode is set to
and
edge point-to-point
Routed Uplink Applies the routed uplink role.
The interface family is set to
CoS parameters are set for schedulers and classifiers.
See Table 57 on page 115
112
ethernet-switching
, port security parameters (MAC
access
for more CoS information.
Enable
check box. The
and
ethernet-switching
, and RSTP is enabled with the
access
options.
inet , and recommended
for more CoS information.
Your Action
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
, port
with the interface.
You can also select an existing VoIP VLAN
configuration or a new VoIP VLAN configuration to
be associated with the interface.
NOTE: VoIP is not supported on EX8200 switches.
2. Click to view CLI commands for this role.
Details
will
3. Click .
OK
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
, port
with the interface. Type the VLAN ID for a new
VLAN.
2. Click to view CLI commands for this role.
Details
3. Click .
OK
To specify an IPv4 address:
1. Select the IPv4 address
2. Type an IP address—for example: 10.10.10.10.
3. Enter the subnet mask or address prefix. For
example, 24 bits represents 255.255.255.0.
4. Click .
OK
To specify an IPv6 address:
1. Select the
IPv6 address
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334.
3. Enter the subnet mask or address prefix.
4. Click .
OK
NOTE: IPv6 is not supported on EX2200 VC
switches.
Copyright © 2017, Juniper Networks, Inc.
check box.
check box.