Defining Cos Rewrite Rules (J-Web Procedure) - Juniper EX Series User Manual

Release History Table
Related
Documentation

Defining CoS Rewrite Rules (J-Web Procedure)

Copyright © 2017, Juniper Networks, Inc.
Release
14.1X53-A2
Defining CoS Forwarding Classes (CLI Procedure)
Example: Configuring CoS on EX Series Switches
Example: Using CoS Forwarding Classes to Prioritize Snooped Packets in Heavy Network
Traffic
Monitoring CoS Forwarding Classes on page 228
Assigning CoS Components to Interfaces (J-Web Procedure) on page 64
Understanding CoS Forwarding Classes
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Class of
Service (CoS) on EX4600 switches.
You can use the J-Web interface to define CoS rewrite rules. Use the rewrite rules to alter
the CoS values in outgoing packets to meet the requirements of the targeted peer. A
rewrite rule examines the forwarding class and loss priority of a packet and sets its bits
to a corresponding value specified in the rule.
To define rewrite rules:
Select >
1. Configure Class of Service
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select
See "Using the Commit Options to Commit Configuration Changes (J-Web
Procedure)" on page 31
Select one of the following options:
2.
—Adds a rewrite rule. Enter information into the rewrite rule page as described
Add
in Table 36 on page 68.
—Modifies an existing rewrite rule. Enter information into the rewrite rule page
Edit
as described in Table 36 on page
Description
J-Web Application package Release 14.1X53-A2 does not support
Class of Service (CoS) on EX4600 switches.
>
Rewrite Rules
for details about all commit options.
68.
Chapter 5: Class of Service Configuration
.
>
Commit Options
.
Commit
67