Juniper EX Series User Manual page 119

Table 52: VLAN Configuration Details (continued)
Field Function
IPv4 address Specifies IPv4 address options for
the VLAN.
IPv6 address Specifies IPv6 address options for
the VLAN.
Voip tab
Ports Specifies the ports to be associated
with this VLAN for voice traffic. You
can also remove the port
association.
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Configuring VLANs for EX Series Switches (CLI Procedure)
Configuring VLANs for EX Series Switches (CLI Procedure)
Example: Setting Up Basic Bridging and a VLAN for an EX Series Switch
Example: Setting Up Basic Bridging and a VLAN for an EX Series Switch
Understanding Bridging and VLANs on EX Series Switches
Chapter 8: Ethernet Switching Configuration
Your Action
Select to enable the IPv4 address options.
IPv4 address
To configure IPv4:
1. Enter the IP address.
2. Enter the subnet mask—for example,
can also specify the address prefix.
3. To apply an input firewall filter to an interface, select the
firewall filter from the list.
4. To apply an output firewall filter to an interface, select
the firewall filter from the list.
5. Click the ARP/MAC Details
address and MAC address in the window that is displayed.
NOTE: In EX4300 switches, you also need to select
in the window that is displayed.
Interface
Select s to enable the IPv6 address options.
IPv6 addres
To configure IPv6:
1. Enter the IP address—for example:
2001:ab8:85a3::8a2e:370:7334
2. Specify the subnet mask.
Click one of the following options:
—Select the ports from the list of available ports. For
Add
an EX8200 Virtual Chassis configuration, select the
member, FPC, and the interface from the list.
—Select the port that you do not want associated
Remove
with the VLAN.
. You
255.255.255.0
button. Enter the static IP
L2
.
99