Juniper EX Series User Manual page 99

Table 44: Port Mirroring Configuration Settings (continued)
Field
Loss Priority
NOTE: This option is not
supported on EX4300
switches.
Analyzer Port
Analyzer Type
NOTE: This option is
supported only on EX4300
switches.
No Filter check
NOTE: This option is
supported only on EX4300
switches.
Ingress
Egress
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Function
Specifies the loss priority of the mirrored packets.
By default, the switch applies a lower priority to
mirrored data than to regular port-to-port
data—mirrored traffic is dropped in preference
to regular traffic when capacity is exceeded.
For port-mirroring configurations with output to
an analyzer VLAN, set the loss priority to high.
Specifies a local interface or VLAN to which
mirrored packets are sent.
NOTE: A VLAN must have only one associated
interface to be specified as an analyzer interface.
Specifies the analyzer type.
Enable this option to skip checking for filters on
port-mirroring instance.
Specifies interfaces or VLANs for which entering
traffic is mirrored.
Specifies interfaces for which exiting traffic is
mirrored.
Configuring Port Mirroring to Analyze Traffic (CLI Procedure)
Example: Configuring Port Mirroring for Local Monitoring of Employee Resource Use on
EX Series Switches
Example: Configuring Port Mirroring for Remote Monitoring of Employee Resource Use
on EX Series Switches
Understanding Port Mirroring on EX Series Switches
Chapter 6: Security and Management Configuration
Your Action
Keep the default of low, unless the output is
to a VLAN.
Click . In the Select Analyzer Port/VLAN
Select
window, select either port or VLAN as the
. Next, select the required port
Analyzer Type
or VLAN. For an EX8200 Virtual Chassis
configuration, select the member, FPC, and
the port (interface) from the list.
Select the from the list.
Analyzer Type
To enable this option, select the check box.
Click . For an EX8200 Virtual Chassis
Add
configuration, select the member, FPC, and
the interface from the list.
Click to delete an ingress interface or
Remove
VLAN.
Click and select or
Add Port
EX8200 Virtual Chassis configuration, select
the member, FPC, and the interface from the
list.
Click Remove to remove egress interfaces.
. For an
VLAN
79