Juniper EX Series User Manual page 73

Table 30: Secure Management Access Configuration Summary (continued)
Field Function
Management Port Specifies the management port IP
IP/Management Port address. The software supports both
IPv6 IPv4 ( displayed as IP) and IPv6 address.
NOTE:
and EX 4500 switches.
Default Gateway Defines a default gateway through which
to direct packets addressed to networks
that are not explicitly listed in the bridge
table constructed by the switch.
Loopback address Specifies the IP address of the loopback
interface.
Subnet Mask Specifies the subnet mask for the
loopback interface.
Services tab
Services Specifies services to be enabled: telnet
and SSH.
Enable Junos XML Enables clear text access to the Junos
management protocol XML management protocol XML
over Clear Text scripting API.
Copyright © 2017, Juniper Networks, Inc.
IPv6 is not supported on EX2200
Chapter 4: System Basics Configuration
Your Action
To specify an IPv4 address:
1. Select the check box
IPv4 address
2. Type an IP address—for example:
NOTE: In J-Web Application package Release
14.1X53-A2, EX4600 switches display two management
ports, em0 and em1. In Type the IP address and subnet
mask for any of the two management ports.
3. Enter the subnet mask or address prefix. For example,
24 bits represents
255.255.255.0
4. Click .
OK
To specify an IPv6 address:
1. Select the check box
IPv6 address
2. Type an IP address—for
example: 2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address prefix.
4. Click .
OK
For IPv4 address type a 32-bit IP address, in dotted decimal
notation. Type a 128-bit IP address for IPv6 address type.
Type an IP address.
Enter the subnet mask or address prefix.
Select to enable the required services.
To enable clear text access, select the
management protocol over Clear Text
.
.
10.10.10.10
.
.
.
Enable Junos XML
check box.
53