Table 56: Port Edit Options - Juniper EX Series User Manual

Table 56: Port Edit Options

Field Function
Port Role Options
Port Role Specifies a profile (role) to assign to the interface.
NOTE: After a port role is configured on the interface,
you cannot specify VLAN options or IP options.
NOTE: Port roles are not supported by the et
interfaces (40-Gigabit Ethernet interfaces) on
EX4300 and EX4550 switches.
NOTE: Only the following port roles can be applied
on EX8200 switch interfaces:
Default
Layer 2 uplink
Routed uplink
Default Applies the default role.
The interface family is set to
mode is set to
To enable security configuration, select the
Security Configuration
forwarding-options dhcp-security-arp-inspection
be configured.
Desktop Applies the desktop role.
The interface family is set to
mode is set to
and
point-to-point
parameters (MAC limit =1; dynamic ARP inspection
and DHCP snooping enabled) are set.
To enable security configuration, select the
Security Configuration
forwarding-options dhcp-security groups
forwarding-options dhcp-security-arp-inspection
be configured.
Copyright © 2017, Juniper Networks, Inc.
NOTE: To enable or disable the administrative status of a selected
interface, click
Enable Port
ethernet-switching
, and RSTP is enabled.
access
Enable
check box. The
ethernet-switching
, RSTP is enabled with the
access
options, and port security
Enable
check box. The
and
or .
Disable Port
Your Action
1. Click to view CLI commands for this role.
Details
, port
2. Click .
OK
will
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
, port
with the interface.
edge
2. Click to view CLI commands for this role.
Details
3. Click OK .
will
Chapter 9: Interfaces
111