Trim Removal/Installation -Rear Side Area - Honda Civic 2002-2003 Service Manual

•
•
•
Trim Removal/Installation - Rear Side Area
NOTE:
• Put on gloves to protect your hands.
• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
• Take care not to bend or scratch the trim and panels.
1. To remove the rear side trim panel, remove these items:
Rear seat cushion and rear seat-back (see page 20-801
Cargo floor mat and cargo area floor (see page 20-521
Rear trim panel (see page 20-521
2. Remove the trim as shown. On the right side, disconnect the cargo compartment light connector.
3. Install the trim in the reverse order of removal, and note these items:
Replace any damaged clips.
Make sure the cargo compartment light connector is plugged in properly.
=
If the threads on the rear side trim panel mounting self-tapping ET screws are worn out, use an oversized self-
tapping ET screw (PIN 90137-S1A-E0111 made specifically for this application .
• When installing the rear side shelf, slip the rear seat belt through the slit in the trim .
• Apply liquid thread lock to the anchor bolts before reinstallation.
Before installing the anchor bolts, make sure there are no twists or kinks in the belt.
Fastener Locations
A[>:Clip,11 BC> Clip,2
c
C>:
Clip, 1
" ':~,
__
~ T-_~~~:~L;::::LF
~,,!,EW A~-
REAR SIDE TRIM PANEL
LID
~ ~., A~~
REAR SEAT BELT
1
~
REAR SEAT
I i , . .
STRIKER C A P . B·PILLAR
SHELF
~~
'::- - ,
SELF-TAPPING
SCREWS
5xO.8mm
4N·m
(0.4 kgf.m. 3 Ibf·ft)
-Aif' A . - ' ,
. -SiD
<1''''if'
Aif'
REAR SPEAKER
CONNECTOR
~~'d~
.
4l~1~~~~t ~oo~.,"m.
- - 0
----FRONT SEAT BElT
ANCHOR BOLT 7/16-20UNF
32N-m
REAR BULKHEAD 7/1S-20UNF (33 kgf.m 24Ibf.ft)
COVER REAR SPEAKER COVER 32 N·m (3.3 kgf.m. 24 Ib'·tt) . •
LOWER ANCHOR CAP
20-51