Honda Civic 2002-2003 Service Manual page 1116

•
28. Check resistance between the NO.3 terminal of
SRS unit connector A (18PI and the No.2 terminal
of dashboard wire harness B connector S. There
should be 0-1.0
Q.
DASHBOARD WIRE HARNESS B CONNECTOR S
Wire side of
female terminals
SRS UNIT CONNECTOR A (18PI
Wire side of female terminals
Is the resistance as specified?
YES-Open in the under-dash fuse/relay box or
poor contact at dashboard wire harness B
connectors; check the connection. If the connection
is OK, replace the under-dash fuse/relay box .•
NO-Open in dashboard wire harness B; replace
dashboard wire harness B .•
29. Turn the ignition switch OFF.
30. Disconnect SRS unit connector C (8P) from the SRS
unit (see step 7 on page 23-22).
31. Connect the NO.3 terminal of SRS unit connector A
(18P) and the No.5 terminal of SRS unit connector
C (8P) with a jumper wire.
SRS UNIT CONNECTOR C (8P)
PNK
JUMPER
WIRE
Wire side of female terminals
PNK
SRS UNIT CONNECTOR A (18P)
Wire side afternale terminals
32. Turn the ignition switch ON
(II).
33. Check the SRS indicator.
Did the SRS indicator go off?
YES-Faulty SRS unit; replace the SRS unit (see
page 23-122) .•
NO - Go to step 34.
34. Turn the ignition switch OFF.
35. Disconnect the jumper wire between the NO.3
terminal of SRS unit connector A (18P) and the
No.5 terminal of SRS unit connector C (8P).
36. Check the No. 13
(lOA)
fuse in the under-dash
fuse/relay box.
Is the fuse OK?
YES-Go to step 40.
NO-Go to step 37.
37. Replace the No. 13
(lOA)
fuse.
(cont'd)
23-109