Honda Civic 2002-2003 Service Manual page 479

Drivelinel Axle
Driveshafts Reassembly (cont'd)
6. Pack the inboard joint with the joint grease
included in the new driveshaft set.
Grease quantity
Inboard joint: 130-140 9 (4.6-4.9 oz)
~
Use the grease included in the
inboard boot set.
7. Fitthe inboard joint onto the driveshaft, and note
these items:
• Reinstall the inboard joint onto the driveshaft by
aligning the marks (A) on the inboard joint and
the rollers.
Hold the driveshaft so the inboard joint is
pointing up to prevent it from falling off.
16-12
A
8. Make sure the ends of the boot are seated in the
grooves in the driveshaft and joint, then install the
boot bands.
• Forthe double loop type, go to step 12.
(Replacement boot bands only)
• For the low profile type, go to step 9.
9. Install the new low profile band (A) onto the boot
(8), then hook the tab (C) of the band.
B
\
~~
c
10. Close the hook portion of the band (A) with a
commercially available boot band pincers (8), then
hook the tabs of the band.
11. Install the boot band on the other end of the boot.
and repeat steps 9 and 10.