Honda Civic 2002-2003 Service Manual page 483

Drivelinel Axle
Driveshafts Reassembly (cont'd)
6. Check the alignment of the paint mark (A) with the
outboard joint end (8).
A
7. Pack the outboard joint (A) with the joint grease
included in the new joint boot set.
Grease quantity
Outboard joint: 105-1159(3.7-4.10zl
~
Use the grease included in the
outboard boot set.
16-16
A
8. Adjust the length of the driveshafts to the figure
below, then adjust the boots to halfway between
full compression and full extension. Make sure the
ends of the boots seat in the grooves of the
driveshaft and joint.
left driveshaft: 497 502 mm (19.6-19.8 in.)
r--- ----_._-
~~--~
Rig~t driveshaft: 475-480 mm 118.7-18.9 in.) ..
_ -
9. Fit the boot (A) ends onto the driveshaft (8) and
outboard joint (C).
A
B