Open In Driver's Airbag Inflator; Increased Resistance In Driver's Airbag Inflator - Honda Civic 2002-2003 Service Manual

SRS
OTe Troubleshooting
OTC 1·1:
Open in Driver's Airbag Inflator
OTC 1·2:
Increased Resistance in Driver's
Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES~Go
to step 3.
NO~lntermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 4P connector (A)
from the cable reel.
) L / / •
~ ~_/
~?(
07SAZ-TB4011A
07XAZ-SZ30100
-~
tw
5. Connect the SRS inflator simulator (2
Q
connectors) and the simulator lead F to the cable
reel.
23-36
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC .
Is OTC 1-1 or OTC 1-2 indicated?
YES~Go to step 9.
NO-Open or increased resistance in the driver's
airbag inflator; replace the driver's airbag (see page
23-113) .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's airbag 4P
connector from dashboard wire harness B (see step
3 on page 23-21).
11. Disconnect both seat belt tensioners 2P connectors
from the floor wire harness (see step 5 on page 23-
22).
12. Disconnect SRS unit connector A (18P) from the
SRS unit (see step 7 on page 23-22). Do not
disconnect the special tool from the cable reel.