Honda Civic 2002-2003 Service Manual page 1057

SRS
DTe Troubleshooting (cont'd)
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is OTC 3-3 indicated?
YES-Go to step 9.
NO-Short in the driver's seat belt tensioner;
replace the driver's seat belt (see page 23-41..
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect floor wire harness 4P connector C403
(AI from dashboard wire harness B.
A
07SAZ-TB401IA
07XAZ-SZ30100
11. Connect the SRS inflator simulator 12
Q
connectors) and simulator lead F to dashboard wire
harness 8.
12. Reconnect the battery negative cable.
13. Erasethe DTC memory.
14. Read the DTC.
Is OTC 3-3 indicated?
YES-Go to step 15.
NO-Short in the floor wire harness; replace the
floor wire harness .•
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
23-50
16. Disconnect the driver's airbag connector (see step
2 on page 23-21), front passenger's airbag
connector Isee step 3 on page 23-21), and front
passenger's seat belt tensioner connector (see step
5 on page 23-22).
17. Disconnect SRS unit connector A 118P) from the
SRS unit Isee step 7 on page 23-22).
18. Disconnect the special tool from dashboard wire
harness B.
19. Check resistance between the No.8 terminal and
the No. 17 terminal of SRS unit connector A 118P).
There should be an open circuit. or at least 1 M
Q.
SRS UNIT CONNECTOR A (ISP)
RED/WHT
RED/BLU
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit; replace the SRS unit Isee
page 23-122) .•
NO--Short in dashboard wire harness B; replace
dashboard wire harness B .•