Honda Civic 2002-2003 Service Manual page 1050

, J
13. Check resistance between the No.4 and No. 13
terminals and between the No.5 and No. 14
terminals of SRS unit connector A (18P). There
should be 2.0-3.0
Q.
SRS UNIT CONNECTOR A Il8PI
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit or poor contact at SRS unit
connector A (18P). Check the connection; if the
connection is OK, replace the SRS unit (see page
23-122) .•
NO-Open or increased resistance in dashboard
wire harness B; replace dashboard wire
harness B .•
OTe 2-3: Short to Another Wire or Decreased
Resistance in Front Passenger's Airbag
Inflator
Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector (A) from dashboard wire harness B.
A
07SAZ-TB40llA
.~
~~
.•
~
G::
07XAZ·SZ30100
5. Connect the SRS inflator simulator (2
Q
connectors) and the simulator lead F to dashboard
wire harness B.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
(conl'd)
23-43