Honda Civic 2002-2003 Service Manual page 1100

5. Disconnect the floor wire harness 2P connector (A)
from the driver's side impact sensor.
6. Disconnect SRS unit connector B (18P) from the
SRS unit (see step 7 on page 23-22).
7. Check resistance between the NO.8 terminal of
SRS unit connector B (18P) and body ground. There
should be an open circuit, or at least 1 M
Q.
SRS UNIT CONNECTOR B IISP)
BRN/YEL
Wire side offemale terminals
Is the resistance as specified?
YES-Go to step 8.
NO-Short to ground in the floor wire harness;
replace the floor wire harness .•
8. Check resistance between the No.8 and No. 15
terminals of SRS unit connector B (18P). There
should be an open circuit, or at least 1 M
Q.
SRS UNIT CONNECTOR B
IISPI
BRN/VEL
LTGRN/RED
Wire side of female terminals
Is the resistance as specified?
YES-Faulty driver's side impact sensor or SRS
unit; replace the driver'S side impact sensor (see
page 23-125). If the problem is still present, replace
the SRS unit (see page 23-122) .•
NO-Short in the floor wire harness; replace the
floor wire harness .•
23-93