Honda Civic 2002-2003 Service Manual page 1056

•
l
• J
16. Disconnect the driver's airbag connector (see step
2 on page 23-211. front passenger's airbag
connector (see step 3 on page 23-211. and front
passenger's seat belt tensioner connector (see step
5 on page 23-22).
17. Disconnect SRS unit connector A (18P) from the
SRS unit (see step 7 on page 23-22). Do not
disconnect the special tool from dashboard wire
harness B.
18. Check resistance between the No.8 terminal and
the No. 17 terminal of SRS unit connector A (18P).
There should be 2.0-3.0
Q.
SRS UNIT CONNECTOR A (laPI
RED/WHT
RED/BLU
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit or poor contact at SRS unit
connector A (18P) and the SRS unit. Check the
connection;
jf
the connection is OK, replace the
SRS unit (see page 23-122) .•
NO-Open or increased resistance in dashboard
wire harness 8; replace dashboard wire harness
B .•
DTe 3-3: Short to Another Wire or Decreased
Resistance in Driver's Seat Belt Tensioner
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead C 07TAZ-SZ5011A
• SRS simulator lead F 07XAZ-SZ301 00
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector (A) from the floor wire harness.
A
07SAZ-TB40llA
07TAZ-SZ50"A
/
~G
5. Connect the SRS inflator simulator (2 Q connector)
and simulator lead C to the floor wire harness.
(cont'd)
23-49