Honda Civic 2002-2003 Service Manual page 880

Under-dash Fuse/Relay Box
. , Removal and Installation
•
SRS components are located in this area. Review the
SRS component locations (see page 23-13) and
precautions and procedures (see page 23-14) in the SRS
section before performing repairs or service.
Removal
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the radio's
preset buttons.
2. Disconnect the battery negative cable, then
disconnect the positive cable, and wait at least
three minutes.
3. Remove the driver's dashboard lower cover (see
page 20-59).
4. Disconnect the connectors from the fuse side of the
under-dash fuse/relay box.
r:-:'I
I.!!:.I
5. Remove the mounting bolt, and slide the under-
dash fuse/relay box (A) down from the bracket (8).
6. Disconnect the back side from connectors from the
back of the under-dash fuse/relay box, and remove
the fuse/relay box.
NOTE: The SRS connector is a spring-loaded lock
type (see page 23-11).
Installation
1. Install the under-dash fuse/relay box in the reverse
order of removal and connect all connectors to the
under-dash fuse/relay box.
2. Install the driver's dashboard lower cover.
3. Connect both the negative cable and positive cable
to the battery.
4. Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
5. Confirm that
all
systems work properly.
6. Do the engine control module (ECM) idle learn
procedure (see page 11-139) .
22-49