Honda Civic 2002-2003 Service Manual page 1058

,J
~
J
It
•
ole 3-4: Short to Power in Driver's Seat Belt
lensioner
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead C 07TAZ-SZ5011A
• SRS simulator lead
F
07XAZ-SZ30100
1. Erase the DTC memory (see page 23-26).
2.
3.
4.
Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's seat belt tensioner 2P
connector
(A)
from the floor wire harness.
A
07SAZ-TB4011A
/
A
07TAZ-SZ5011A
~w
5. Connect the SRS inflator simulator (2 " connector)
and simulator lead C to the floor wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 3-4 indicated?
YES-Go to step 9.
NO-Short to power in the driver's seat belt
tensioner; replace the driver's seat belt
(see page 23-4) .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect floor wire harness 4P connector C403
(A) from dashboard wire harness B.
~ • .
- / 07SAZ-TB4011A
/
~
-,>
07XAZ-SZ30100
-t:J
11. Connect the SRS inflator simulator (2 Q
connectors) and simlator lead F to dashboard wire
harness B.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is DTC 3-4 indicated?
YES--Go to step 15.
NO-Short to power in the floor wire harness;
replace the floor wire harness .•
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
(conl'd)
23-51