Honda Civic 2002-2003 Service Manual page 1055

SRS
OTe Troubleshooting (cont'd)
OTC 3-1: Open in Driver's Seat Belt Tensioner
OTC
3-2: Increased Resistance in Driver's
Seat Belt Tensioner
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead C 07TAZ-SZ5011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory Isee page 23-261.
2. Turn the ignition switch ON 1111, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures Isee
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector
(A)
from the floor wire harness.
07TAZ-SZ5011A
"
"
A
07SAZ-TB4011A
, /
FEJ
iC.=C'
'I
'" '~i
_),1
~'""'-----
5. Connect the SRS inflator simulator 12
Q
connectorl
and simulator lead C to the floor wire harness.
23-48
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is OTe 3-1 or OTe 3-2 indicated?
YES-Go to step 9.
NO-Open or increased resistance in the driver's
seat belt tensioner; replace the driver's seat belt
Isee page 23-41 .•
9. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector
C403 IAI from dashboard wire harness B.
0(
"'~-".
/
~ "~~
07XAZ-SZ30100
::0
11. Connect the SRS inflator simulator 12
Q
connectors) and simulator lead F to dashboard wire
harness B.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is OTe 3-1 or OTe 3-2 indicated?
YES-Go to step 15.
NO-Open or increased resistance in the floor wire
harness; replace the floor wire harness .•
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
~
..J
\..
,.I