Honda Civic 2002-2003 Service Manual page 1094

11. Disconnect SRS unit connector B (18PI from the
SRS unit (see step 7 on page 23-221. Do not
disconnect the special tool from the floor wire
harness 2P connector.
12. Check resistance between the No.7 and No. 18
terminals ofSRS unit connector B (18PI. There
should be 2.0-3.0
[2.
SRS UNIT CONNECTOR B 118P)
WHT/RED
WHT/GRN
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit or poor contact at SRS unit
connector B 118P) and the SRS unit. Check the
connection; If the connection is OK, replace the
SRS unit Isee page 23-122) .•
NO-Open or increased resistance in the floor wire
harness; replace the floor wire harness .•
OTe 12-3: Short to Another Wire or
Decreased Resistance in Front Passenger's
Side Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the DTC memory Isee page 23-261.
2. Turn the ignition switch ON 1111, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO - Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures Isee
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector (A)
from the front passenger's side airbag.
o
07S~'~
A
nP"
u-
07XAZ-SIA0200
5. Connect the SRS inflator simulator 12
Q
connectorl
and simulator lead E to the floor wire harness.
(conl'dl
23-87