Honda Civic 2002-2003 Service Manual page 1060

•
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is OTC 3-5 indicated?
YES-Go to step 9.
NO-Short to ground in the driver's seat belt
tensioner; replace the driver's seat belt
(see page 23-41 .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect floor wire harness 4P connector C403
(AI
from dashboard wire harness
B.
A
c(
07SAZ-TB4011A
/
~ -r;~c
07XAZ-SZ30100
-c
11. Connect the SRS inflator simulator (2
Q
connectors) and simulator lead F to dashboard wire
harness B.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is OTC
3-5
indicated?
YES-Go to step 15.
NO-Short to ground in the floor wire harness;
replace the floor wire harness .•
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes .
16. Disconnect the driver's airbag connector (see step
2 on page 23-21), front passenger's airbag
connector (see step 3 on page 23-211, and front
passenger's seat belt tensioner connector (see step
5 on page 23-22).
17. Disconnect SRS unit connector A (18P) from the
SRS unit (see step 7 on page 23-221.
18. Disconnect the special tool from dashboard wire
harness
B.
19. Check resistance between the No.8 terminal of
SRS unit connector A (18P) and body ground, and
the No. 17 terminal and body ground. There should
be an open circuit, or at least 1 M
Q.
SRS UNIT CONNECTOR A 11BPI
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit; replace the SRS unit (see
page 23-122) .•
NO-Short to ground in dashboard wire harness B;
replace dashboard wire harness B .•
23-53