Table of Contents
Advertisement
SRS
OTC Troubleshooting (cont'd)
11. Disconnect SRS unit connector B (18PI from the
SRS unit (see step 7 on page 23-221. Do not
disconnect the special tool from the floor wire
harness 2P connector.
12. Check resistance between the No.6 and No. 17
terminals of SRS unit connector
B
(18PI. There
should be 2.0-3.0
Q.
SRS UNIT CONNECTOR B (18PI
WHT/BLU
WHT/BLK
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit or poor contact at SRS unit
connector B (18PI and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 23-1221 .•
NO-Open or increased resistance in the floor wire
harness; replace the floor wire harness .•
23-82
OTe "-3: Short to Another Wire or
Decreased Resistance in Driver's Side Airbag
Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the DTC memory (see page 23-261.
2. Turn the ignition switch ON (III, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector (A)
from the driver's side airbag.
o
A
/07SAZ-TB40llA
~~A
07XAZ-S1A0200
-u
5. Connect the SRS inflator simulator (2
Q
connectorl
and simulator lead E to the floor wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
Advertisement
Table of Contents
Troubleshooting
