Honda Civic 2002-2003 Service Manual page 1045

Table of Contents

Advertisement

SRS
OTC Troubleshooting (cont'd)
8. Read the DTC.
Is DTC 1-3 indicated?
YES-Go to step 9.
NO-Short in the driver's airbag; replace the
driver's airbag (see page 23-113) .•
9.
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's airbag 4P
connector
from dashboard wire harness
B
(see step
3 on page 23-21).
11. Disconnect both seat belt tensioner 2P connectors
from the floor wire harness (see step 5 on page 23-
22).
12. Disconnect SRS unit connector A (18P) from the
SRS unit (see step 7 on page 23-22).
13. Disconnect the special tool from the cable reel.
23-38
14. Check resistance between the No.7 and the No. 16
terminals and between the No.6 and the No. 15
terminals of SRS unit connector A (18P). There
should be an open circuit. or at least 1 M
Q.
SRS UNIT CONNECTOR A (18P)
GRN/WHT
GRN/RED
, - - - - - - ' - - - - ,
GRN/YEL
GRN/BLK
Wire side of female terminals
Is the resistance as specified?
YES-Faulty SRS unit; replace the SRS unit (see
page 23-122) .•
NO-Go to step 15.
15. Disconnect the cable reel from dashboard wire
harness B. Check resistance between the No.7 and
the No. 16 terminals and between the NO.6 and the
No. 15 terminals of SRS unit
connector
A (18P).
There should be an open circuit, or at least 1 M
Q.
Is the resistance as specified?
YES-Replace the cable
reel..
NO-Replace dashboard wire harness
B..

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents