Disconnecting System Connectors - Honda Civic 2002-2003 Service Manual

SRS
Precautions and Procedures (cont'd)
Disconnecting System Connectors
Before removing a front airbag, side airbag, or other SRS related devices (the SRS unit, the cable reel, the front impact
sensors, the side impact sensors, the seat belt buckle tensioners, and the seat belt tensioner connector), disconnecting
connectors from related devices, or removing the dashboard or the steering column, disconnect the airbag connectors
or the side airbag connectors to prevent accidental deployment.
Turn the ignition switch OFF, disconnect the negative cable from the battery, and wait at least 3 minutes before
beginning the following procedures .
• Before disconnecting SRS unit connector A (1) from the SRS unit, disconnect the driver's airbag 4P connector (3),
the front passenger's airbag 4P connector (4), the driver's seat belt tensioner 2P connector (6), and the front
passenger's seat belt tensioner 2P connector (7).
Before disconnecting SRS unit connector B (8) from the SRS unit, disconnect both side airbag 2P connectors (11, 12),
and both seat belt buckle tensioner 4P connectors (9, 10).
Before disconnecting the cable reel 4P connector (2), disconnect the driver's airbag 4P connector (3).
Before d'isconnecting the floor wire harness 4P connector (5), disconnect both seat belt
tens'loner
2P connectors
(6,7).
WIRE HARNESS
23-20
DRIVER'S
SEAl BElT
BUCKLE
nNSIONER
FRONT
PASSENGER'S
SEAT BELT
BUCKLE
FRONT
PASSENGER'S
SIDE IMPACT
SENSOR