Honda Civic 2002-2003 Service Manual page 1066

•
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
S. Read the DTC.
Is OTe 4-1 or OTe 4-2 indicated?
YES-Go to step 9.
NO-Open or increased resistance in the front
passenger's seat belt tensioner; replace the front
passenger's seat belt Isee page 23-4) .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector
C4031A) from dashboard wire harness B.
c(
.
07SAZ·TB4011A
/
~ -r~l
07XAZ·SZ30100
-@
I 1. Connect the SRS inflator simulator 12
,2
connectors) and simulator lead F to dashboard wire
harness B.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is OTe 4-1 or OTe 4-2 indicated?
YES-Go to step 15.
NO-Open or increased resistance in the floor wire
harness; replace the floor wire harness .•
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
16. Disconnect the driver's airbag connector Isee step
2 on page 23-21), front passenger's airbag
connector Isee step 3 on page 23-21), and driver's
seat belt tensioner connector Isee step 5 on page
23-22).
17. Disconnect SRS unit connector A IISP) from the
SRS unit Isee step 7 on page 23-22). Do not
disconnect the special tool from dashboard wire
harness B.
IS. Check resistance between the NO.9 terminal and
the No. IS terminal of SRS unit connector A IISP).
There should be 2.0-3.0
Q.
SRS UNIT CONNECTOR A
IISP}
RED/VEL
RED/BLK
Wire side of female terminals
Is the resistance as specified?
YES-
Faulty SRS unit or poor contact at SRS unit
connector A IISP) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit Isee page 23-122) .•
NO-Open or increased resistance in dashboard
wire harness B; replace dashboard wire harness
B .•
23-59