Faulty Driver's Seat Belt Buckle Switch - Honda Civic 2002-2003 Service Manual

J
DTC 9-3: Faulty Driver's Seat Belt Buckle
Switch
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), then buckle and
unbuckle the driver's seat belt several times.
3. Read the DTC.
Is OTe 9-3 indicated?
YES-Go to step 4.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
4. Turn the ignition switch OFF.
5. Disconnect the driver's seat belt buckle switch 3P
connector
(A)
from the floor wire harness.
a
A
6. Buckle the driver's seat belt.
Check resistance between the No.1 and No.3
terminals of the driver's seat belt buckle switch 3P
connector. There should be 0-1
[2.
Check resistance between the No.1 and No.2
terminals of the same connector. There should be
an open circuit, or at least 1 M
[2.
DRIVER'S SEAT BELT BUCKLE SWITCH
3P CONNECTOR
Terminal side of male terminals
Terminal side of male terminals
Are the resistance readings as specified?
YES-Go to step 7.
NO- Replace the driver's seat belt buckle assembly,
then clear the DTC .•
(conl'd)
23-71