SRS
OTe Troubleshooting (cont'd)
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is
DTe
11-4
indicated?
YES~Go
to step 9.
NO~Short
to power in the driver's side airbag
inflator; replace the driver's side airbag (see page
23-1151 .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's side airbag 2P
connector (see step 4 on page 23-21) and both seat
belt buckle tensioner 4P connectors (see step 6 on
page 23-22).
23-84
11. Disconnect SRS unit connector B (18P) from the
SRS unit (see step 7 on page 23-22).
12. Turn the ignition switch ON (II).
13. Check for voltage between the No.6 terminal of
SRS unit connector B (18P) and body ground, and
between the No. 17 terminal and body ground.
There should be 0.5 V or less.
SRS UNIT CONNECTOR B
(ISP)
Wire side of female terminals
Is
the voltage
as
specified?
YES~
Faulty SRS unit; replace the SRS unit (see
page 23-122) .•
NO~Short
to power in the floor wire harness;
replace the floor wire harness .•