Opds Unit Replacement - Honda Civic 2002-2003 Service Manual

SRS
OPDS Unit Replacement
NOTE: Review the seat replacement procedures in the
body section before performing repairs or service.
Removal
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Disconnect the passenger's side airbag harness 2P
connector (see step 4 on page 23-211.
3. Remove the front passenger's seat assembly (see
page 20-711 and seat-back cover (see page 20-751.
4. Remove the cover (AI, then disconnect the OPDS
unit harness 8P and sensor connectors (BI from the
OPDS unit.
B
5. Remove the two screws
(el
and the OPDS unit (DI.
23-124
Installation
1. Place the new OPDS unit (AI on the seat-back frame.
Tighten the two screws (BI, and connect the OPDS
unit harness 8P and sensor connectors (C) to the
OPDS unit. Reinstall the cover (DI.
A
B
c
2. Install the seat-back cover (see page 20-751.
3. Install the seat assembly (see page 20-711, then
connect the side airbag harness 2P connector.
4. Reconnect the battery negative cable.
5. Set the seat-back in the normal position, and make
sure there is nothing on the front passenger's seat.
6. Initialize the OPDS unit (see page 23-271.
7. After installing the OPDS unit, confirm proper
system operation: Turn the ignition switch ON (III;
the SRS indicator should come on for about 6
seconds and then go off.