Honda Civic 2002-2003 Service Manual page 1093

SRS
DTe Troubleshooting (cont'd)
DTe 12-1: Open or Increased Resistance in
Front Passenger's Side Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the OTC memory (see page 23-261.
2. Turn the ignition switch ON (III, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector (AI
from the front passenger's side airbag.
07S~
A
AP,
i-JI-
07XAZ-S1A0200
5. Connect the SRS inflator simulator (2
Q
connectorl
and simulator lead E to the floor wire harness.
23-86
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the OTC .
Is OTe 12-1 indicated?
YES-Go to step 9.
NO-Open or increased resistance in the front
passenger's side airbag inflator; replace the front
passenger's side airbag (see page 23-1151 .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the driver's side airbag 2P connector
(see step 4 on page 23-211 and both seat belt buckle
tensioner 4P connectors (see step 6 on page 23-221.