Honda Civic 2002-2003 Service Manual page 480

•
•
•
12. Fit the boot ends onto the driveshaft and the
inboard joint, then install the new double loop band
(A) onto the boot.
13. Pull up the slack in the band by hand.
14. Mark a position (A) on the band 10-14 mm (0.4-
0.6 in.) from the clip (8) .
15. Thread the free end of the band through the nose
section of the commercially available boot band
tool KD-3191 or equivalent (A), and into the slot on
the winding mandrel (B).
A
\
c
16. Place a wrench on the winding mandrel of the boot
band tool, and tighten the band until the marked
spot (C) on the band meets the edge of the clip.
17. Lift up the boot band tool to bend the free end of
the band 90 degrees to the clip. Center-punch the
clip, then fold over the remaining tail onto the clip .
(cont'd)
16-13