Honda Civic 2002-2003 Service Manual page 1098

OTe 13·3: No Signal from the Driver's Side
Impact Sensor
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Check the connection between the floor wire
harness 2P connector and the driver's side impact
sensor.
Is the connection OK?
YES-Go to step 5.
NO-Replace the driver's side impact sensor and/
or the floor harness, as needed . •
5. Disconnectthe driver's side airbag and front
passenger's side airbag 2P connectors (see step 4
on page 23-21). Also disconnect both seat belt
buckle tensioner 4P connectors (see step 6 on page
23-22) .
6. Disconnect the floor wire harness 2P connector (A)
from the driver's side impact sensor.
0;:.:...--------
07SAZ-TB4011A
I====,-,
I
7. Connect the SRS inflator simulator (2
Q
connector)
and simulator lead H to the floor wire harness.
(conl'd)
23-91