•
•
•
11. At the wire harness side, check lor continuity
between TP sensor 3P connector terminal No.2
and body ground.
TP SENSOR 3P CONNECTOR
Wire side of female terminals
Is there continuity?
YES-Repair short in the wire between the ECM
(A 151 and the
TP
sensor..
NO-Go to step 12.
12. Connect ECM connector terminal A15 to body
ground with a jumper wire.
ECM CONNECTOR A
131P)
1 21 3 1 4
5 6 71
1/ 9
10 111121/1/ 1516 1/118119 20 21
22231241
~
27128129 30 1/
TPS
JUMPER WIRE
IRED/BlK)
Wire side of female terminals
13. At the wire harness side, check lor continuity
between TP sensor 3P connector terminal No.2
and body ground.
TP SENSOR 3P CONNECTOR
=
Wire side of female terminals
Is there continuity?
YES-Update the ECM il it does not have the latest
software, or substitute a known-good ECM, then
recheck (see page 11-61. II the symptom/indication
goes away with a known-good ECM, replace the
original ECM .•
NO- Repair open in the wire between the ECM
(A151 and the TP sensor..
14. Measure voltage between ECM connector
terminals A10 and A20.
ECM CONNECTOR
A
(31PI
Wire side of female terminals
Is there about 5 V?
YES-Repair open in the wire between the ECM
(A201 and the TP sensor .•
NO-Update the ECM il it does not have the latest
software, or substitute a known-good ECM, then
recheck (see page 11-6), If the symptom indication
goes away with a known-good ECM. replace the
original ECM .•
11-61