Honda Civic 2002-2003 Service Manual page 1099

SRS
OTe Troubleshooting (cont'd)
8. Disconnect SRS unit connector B (18P) from the
SRS unit (see step 7 on page 23-22).
9. Check resistance between the No.8 and No. 15
terminals of SRS unit connector B (18P). There
should be 0-1.0
Q.
SRS UNIT CONNECTOR B
(18PI
BRN/VEL
LT GRN/RED
Wire side of female terminals
Is the resistance as specified?
YES-Faulty driver's side impact sensor or SRS
unit; replace the driver's side impact sensor (see
page 23-123). If the problem is still present, replace
the SRS unit (see page 23-122) .•
NO-Open in the floor wire harness; replace the
floor wire harness .•
23-92
OTe 13-4: Faulty Power Supply to the Driver's
Side Impact Sensor
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON
(II),
and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's side airbag and front
passenger's side airbag 2P connectors (see step 4
on page 23-21). Also disconnect both seat belt
buckle tensioner 4P connectors (see step 6 on page
23-22).
J