Honda Civic 2002-2003 Service Manual page 1048

Table of Contents

Advertisement

l
,
,
8. Read the DTC.
Is OTe 1-5 indicated?
YES~Go
to step 9.
NO~Short
to ground in the driver's airbag inflator;
replace the driver's airbag (see page 23-1131 .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnectthe front passenger's airbag 4P
connector from dashboard wire harness B (see step
2 on page 23-21).
11. Disconnect both seat belttensioner 2P connectors
from the floor wire harness (see step 5 on page 23-
221.
12. Disconnect SRS unit connector A (18PI from the
SRS unit (see step 7 on page 23-221.
13. Disconnect the special tool from the cable reel.
14. Check resistance between the No.7 terminal of
SRS unit connector A (18PI and body ground, the
No. 16 terminal and body ground, the No.6
terminal and body ground, and the No. 15 terminal
and body ground. There should be an open circuit,
or at least 1 M
Q.
SRS UNIT CONNECTOR A
(1aPI
GRN/WHT
GRN/RED
Q
Q
Wire side of female terminals
Is the resistance
as
specified?
YES~Faulty
SRS unit; replace the SRS unit (see
page 23-1221 .•
NO~Gotostep
15.
15. Disconnect the cable reel from dashboard wire
harness B.
16. Check resistance between the No.7 terminal of
SRS unit connector A (18PI and body ground, the
No. 16 terminal and body ground, the No.6
terminal and body ground, and the No. 15 terminal
and body ground. There should be an open circuit,
or at least 1 M
Q.
Is the resistance
as
specified?
YES~Replace
the cable reel..
NO~Replace
dashboard wire harness
B .•
23-41

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents