A Problem In The Mode Control Linkage, Doors, Or Motor - Honda Civic 2002-2003 Service Manual

6. Turn the ignition switch OFF, and check for
continuity between the following terminals of
heater control panel connectors A (14P) and B (22P)
and the mode control motor 1 OP connector.
14P: 10P:
No.2 No.10
No.10 No.1
No.11 No.2
22P: 10P:
No.17 NO.8
No. 18 No.6,9
No.19 No.5
No. 20 No.4,7
HEATER CONTROL PANEL CONNECTOR A (14P)
Wire side offemale terminals
Q
Q
LTGRN
1 2 3
WHT/BLU
4 5 6
YEL/GRN
MODE CONTROL MOTOR lOP CONNECTOR
Wire side of female terminals
HEATER CONTROL PANEL CONNECTOR B (22P)
Wire side of female terminals
Is there continuity?
YES-Check for loose wires or poor connections at
heater control panel connectors A (14P) and B (22P),
and at the mode control motor 1 OP connector. If the
connections are good, substitute a known·good
mode control motor, and recheck. If the symptom/
indication goes away, replace the original mode
control
motor. If
the symptom/indication continues,
substitute a known-good heater control panel, and
recheck. If the symptom/indication goes away,
replace the original heater control panel..
NO-Repair any open in the wire(s) between the
heater control panel and the mode control motor .•
DTC 11: A Problem in the Mode Control
Linkage, Doors, or Motor
1. Testthe mode control motor (see page 21-35).
Is the mode control motor OK?
YES-Substitute a known-good heater control
panel, and recheck. If the symptom/indication goes
away, replace the original heater control panel..
NO-Replace the mode control motor, or repair the
linkage and doors .•
21-19