Short To Ground In Driver's Airbag Inflator - Honda Civic 2002-2003 Service Manual

SRS
OTC Troubleshooting (cont'd)
15. Turn the ignition switch ON (III.
16. Check for voltage between the NO.7 terminal of
SRS unit connector A (18PI and body ground, the
No. 16 terminal and body ground, the No.6
terminal and body ground, and the No. 15 terminal
and body ground. There should be 0.5 V or less.
SRS UNIT CONNECTOR A
Il8P)
Wire side of female terminals
Is the voltage as specified?
YES-Faulty SRS unit; replace the SRS unit (see
page 23-1221 .•
NO-Go to step 17.
17. Turn the ignition switch OFF.
18. Disconnect the cable reel from dashboard wire
harness B.
19. Turn the ignition switch ON (III.
20. Check for voltage between the No.7 terminal of
SRS unit connector A (18PI and body ground, the
No. 16 terminal and body ground, the No.6
terminal and body ground, and the No. 15 terminal
and body ground. There should be 0.5 V or less.
Is the voltage as specified?
YES-Replace the cable reel..
NO~Replace
dashboard wire harness B .•
23-40
Ole '-5: Short to Ground in Driver's Airbag
Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-261.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 4P connector (AI
from the cable reel.
- ---
",
A
'000"."-
I
?(
07SAZ·TB40llA
/
~ "~~
07XAZ·SZ30100
::©
5. Connect the SRS inflator simulator (2
Q
connectorsl and the simulator lead F to the cable
reel.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.