Honda Civic 2002-2003 Service Manual page 541

EPS Components
Motor Removal/Installation (cont'd)
Installation
7. Clean the mating surface of the motor (AI and
gearbox.
B
~
/
8X1.25mm
20N·m
(2.0 kgf·m. 7 2 Ibf·ftJ
,
o
8. Apply a thin coat of silicone grease !PIN 08733-
B070E) to the new O-ring (B), and carefully fit it on
the motor.
9. Apply grease (Nippon Grease WR-S or equivalent
steering gear grease) into the motor shaft (C).
17-50
10. Install the motor on the gearbox by engaging the
motor shaft and worm shaft (D). Note the motor
installation position (direction of motor wires).
11. Before tightening the bolts, turn the motor two or
three times right and left about 45 degrees. Make
sure the motor is evenly seated on the steering
gearbox and that the O-ring is not pinched between
the mating surfaces.
12. Install the removed parts in the reverse order of
removal, and note these items:
• Make sure the motor 2P connector is properly
connected .
• Make sure the motor and EPS wires are not
caught or pinched by any parts.
Reconnect the negative cable to the battery.
Do the engine control module (ECM) idle learn
procedure (see page 11-139).
Enter the anti-theft code for the radio station
presets. Reset the clock.
Do the power window control unit reset
procedure (see page 22-128).
13. After installation, start the engine, and let it idle.
Turn the steering wheel from lock-to-Iock several
times. Check that the EPS indicator does not come
on.
•
•