Honda Civic 2002-2003 Service Manual page 1088

Table of Contents

Advertisement

OTe 11-1:
Open or Increased Resistance in
Driver's Side Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the DTC memory Isee page 23-261.
2. Turn the ignition switch ON (III, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector IAI
from the driver's side airbag.
o
5. Connect the SRS inflator simulator 12
Q
connectorl
and simulator lead E to the floor wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC .
Is DTC 11-1 indicated?
YES-Go to step 9.
NO-Open or increased resistance in the driver's
side airbag inflator; replace the driver's side
airbag Isee page 23-1151..
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's side airbag 2P
connector Isee step 4 on page 23-21) and both seat
belt buckle tensioner 4P connectors Isee step 6 on
page 23-221.
Icont'dl
23-81

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents